Installations for incineration of wood waste from

Woodworking is a slow production, but it is not waste-free, that is, as much as there is wood, sawdust, woodworking, there is also wood waste that needs to be processed.

In parallel with the colossal growth of the volume of this direction, the requirements for the cleanliness of the processing of products are also increasing, which accordingly increases waste, the processing of which is an ecological and economic problem.

The solution to this problem is ready to be offered by the Lviv enterprise "Metalist" http://www.kotel-metalist.com.ua - namely, equipment that not only disposes of wood, piece waste and agricultural waste (sunflower husks, straw), but also helps get cheap heat in the desired amount. The proposed installations pay for themselves in one season, which indicates the obvious expediency and cost-effectiveness of their introduction into production.

We would like to tell in more detail about the products produced by our factory.

100-2000 kW UEAS power installations

The installations are designed to provide heat for manufacturing processes, hot water supply systems, water heating of drying chambers, premises, greenhouses.

Automatic combustion power plant (UEAS) - consists of a boiler with high heat output and an automatic combustion system of the SAC. For burning forest and sawmill sawdust with a moisture content of up to 70%, we offer САС-500, -800, -1000, -1500, -2000

Installations are universal, because in emergency situations, the technological process is not interrupted due to the burning of lumpy waste in the boiler furnace.

The efficiency of UEAS is more than 76%.

Water heating boilers (firewood, coal, briquettes) kW 40 - 2000 kW

Water heating boilers work on firewood, coal or briquettes. Complete with a fan and a control panel allows you to control them in automatic remote mode with control and regulation of water in the heating system.

Water heating boilers are quite convenient in operation and repair, while they can work in heating systems of large industrial areas and in residential buildings, at a coolant temperature of up to 95 C with any water circulation.

Water heating boilers are universal, they can be main, parallel, alternative and temporary in central heating systems.

Systems of automatic combustion of wood waste

Automatic combustion systems (SAC) consist of a burner - a gas generator and a hopper with a screw mechanism. The main fuel for SAC is wood waste and residues after grain cleaning.

Control of the SAC occurs automatically, with full control of the temperature in the heat carrier. SAS is connected to various types of boilers (water heating, steam, and others).

SAS is quite intensively operated at various drying complexes (drying of sawdust, wood chips, peat for briquetting or granulation, as well as sand for building mixes, etc.).

Wood burners and briquettes

Combustors can be connected to various types of industrial boilers (water heating, steam, etc.) and drying systems (drying sawdust, chips, hops, etc.).

INSTALLATIONS - heat utilization

These installations are based on the principle of pyrolysis, they work according to the gas generator system, and their basis is the smoldering process. It is equipped with a silent turbine fan and a speed regulator.

Nominal heat output, kW 100 150

Pyrolysis boilers

Pyrolysis boilers operate on lumpy wood waste or firewood under the influence of thermal decomposition of wood and are environmentally friendly. Also, they use the principle of smoldering combustion, in the process of which the products of fuel combustion are processed into combustible gas.

Boilers include two combustion chambers. In one - loading, during combustion with the help of air coming from the fan, combustible gas is formed. When air is supplied under the influence of natural draft, this gas is fed into the second chamber, where intensive combustion takes place (efficiency up to 85%).

Complete with a control panel, allows you to control them in automatic remote mode with control and regulation of water in the heating system.

Pyrolysis boilers are extremely convenient in operation and repair, while they can work in heating systems of huge industrial areas and in residential buildings, at a coolant temperature of up to 95C with any water circulation.

Pyrolysis boilers are universal, they can be main, parallel, alternative and temporary in heating systems.

Depending on the quality of the wood used and the temperature, one bookmark for the boiler is enough for 7-12 hours. It is recommended to use firewood with a humidity of up to 20%, higher humidity significantly reduces the boiler's performance.

Aerodynamic drying complex

The complex for drying wood waste differs from others in its high-quality assembly, built-in air heat exchanger.

The aerodynamic complex is used to dry sawdust before making briquettes and pellets. Productivity of the complex - 500-700, 700-1000 kg/hour

Terms of delivery on the website http://www.kotel-metalist.com.ua/